E: Control gear for light sources

E1 (a): High-voltage transformers

Cold-cathode tubes used for signs and high-voltage lighting are operated from transformers with special characteristics.

E1 (b): High-frequency ballasts for cold cathode tubes

This Guideline discusses ballasts to operate cold-cathode tubing at a high frequency, either from low-voltage battery supplies (via invertors) or from standard 50 Hz mains supplies (via convertors).

E2: Control gear and wiring of fluorescent lamps in box signs

This guideline discusses the choice of lamps of various diameters and their effect on sign illumination. It lists the components of a typical gear tray, noting the standards that apply to the various components. Information is given on power-factor correction and the protection of the mains supply.

E3: Suppression of interference

The legal requirements for conformance to the EU Electromagnetic Compatibility Directive (EMCD) are listed. The guideline discusses sources of interference within typical lamp circuits and how they may be minimised.

E4: Lamps and control gear operating at medium voltage

This Guideline is no longer available.

 

E5: High-frequency luminaires (LIF Technical Statement 21)

Use of high-frequency ballasts in luminaires or signs requires special techniques if problems are to be avoided. This guideline (reproduced from an LIF technical note) lists the problems and remedies.

E6: Use of high-frequency ballasts in outdoor signs

High-frequency ballasts are used in many signs, particularly those illuminated by fluorescent lamps. Their reliability is normally very good provided they are not subjected to excessive amounts of moisture. Many ballasts are constructed on printed circuit boards with a varnish protection against the effects of humidity. However, this protection is not suitable if the ballasts are subjected to rainwater, as might occur in outdoor signs. The guideline discusses these problems and suggests ways in which such ballasts may be used outdoors.